Actual Cisco 200-105 Exam Questions

The Cisco 200-105 exam dumps contain valid knowledge to accomplish tasks about WAN technologies, infrastructure services, and infrastructure maintenance.

Try it Latest DumpsSchool 200-105 Exam dumps. Buy Full File here: https://www.dumpsschool.com/200-105-exam-dumps.html (691 As Dumps)

Download the DumpsSchool 200-105 braindumps from Google Drive: https://drive.google.com/file/d/1TwCxP9R2WPXn5O77CUBND73niqczpZDp/view (FREE VERSION!!!)

Question No. 1

Refer to the exhibit.

Which switch in this configuration becomes the root bridge?

Answer: C

Question No. 2

An administrator is troubleshooting a problem between routers that are using different versions of RIP.

Which two commands would provide information about which version of RIP was being sent and received on

an interface? (Choose two.)

Answer: A, E

Question No. 3

Which port type is used in a stacked deployment?

Answer: A

Question No. 4

Which function is performed by a TACACS+ server?

Answer: B

Question No. 5

Which two states are the port states when RSTP has converged? (Choose two.)

Answer: A, D

Understanding Rapid Spanning Tree Protocol (802.1w)

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_white_paper09186a0080094cfa.shtml

Port States

There are only three port states left in RSTP that correspond to the three possible operational states. The 802.1D disabled, blocking, and listening states are merged into a unique 802.1w discarding state.

RSTP only has 3 port states which are discarding, learning and forwarding. When RSTP has converged there are only 2 port states left: discarding and forwarding.

Question No. 6

Which two encapsulation types can use the keepalive command to monitor the link state of a WAN serial

interface? (Choose two.)

Answer: A, D

Question No. 7

You have been asked to come up with a subnet mask that will allow all three web servers to be on the same

network while providing the maximum number of subnets.

Which network address and subnet mask meet this requirement?

Answer: B

Question No. 8

Workstation A has been assigned an IP address of 192.0.2.24/28. Workstation B has been assigned an IP address of 192.0.2.100/28. The two workstations are connected with a straight-through cable. Attempts to ping between the hosts are unsuccessful.

What are two things that could be attempted that would allow communications between the hosts? (Choose two.)

Answer: A, B

Question No. 9

Which two marking methods are supported with the IPv4 header? (Choose two.)

Answer: A, B

Question No. 10

Refer to the exhibit. After you apply the give configurations to R1 and R2 you notice that OSPFv3 fails to start.

Which reason for the problem is most likely true?

Answer: A

Question No. 11

Which tool or utility can report whether traffic matching specific criteria can reach a specified destination on the

ACLs along the path?

Answer: A

Question No. 12

Which identification number is valid for an extended ACL?

Answer: D

Question No. 13

Refer to the exhibit.

Given the partial configuration shown in the exhibit, why do internal workstations on the

192.168.1.0 network fail to access the Internet? A. A NAT pool has not been defined.

Answer: C

Question No. 14

Which two statements about interior gateway routing protocols are true? (Choose two.)

Answer: A, C

200-105 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1TwCxP9R2WPXn5O77CUBND73niqczpZDp/view

Related Certification: CCNA Routing & Switching dumps

120