Question No. 1

Which task must you perform to enable point-to-point frame relay connection?

• A. Disable inverse ARP
• B. Configure the encapsulation type
• C. Enable inverse ARP
• D. Configure static address mapping

Question No. 2

Refer to the exhibit. How does R1 handle the route to network 10.1.80.0/24?

• A. R1 redistributes network 10.1.80.0/24 into EIGRP without changing the mask
• B. R1 changes the mask to /32 and then redistributes network 10.1.80.0/24 into EIGRP as a classful network
• C. R1 changes the mask to /32 and then redistributes network 10.1.80.0/24 into EIGRP as a assless network
• D. R1 fails to redistribute network 10.1.80.0/24 into EIGRP

Question No. 3

Refer to the exhibit.

Which option describes why the EIGRP neighbors of this router are not learning routes that are received from OSPF?

• A. The routing protocols do not have the same AS number.
• B. There is no overlap in the subnets advertised.
• C. The subnet defined in OSPF is not part of area 0.
• D. Default metrics are not configured under EIGRP.

Question No. 4

When an EIGRP router discovers a new neighbor, which packet type does the router send to help the neighbor build its topology table?

• A. replies
• B. requests
• C. updates
• D. queries

Question No. 5

Which option is one way to mitigate symmetric routing on an active/active firewall setup for TCP based connections?

• A. performing packet captures
• B. disabling asr-group commands on interfaces that are likely to receive asymetnc traffic
• C. replacing them with redundant routers and allowing load balancing
• D. disabling stateful TCP checks

Question No. 1

Which feature or technology is supported with stateful NAT64?

• A. FTP and ICMP on an application layer gateway
• B. VFR
• C. IP multicast
• D. NAT44 and NAT64 on the same interface

Question No. 2

What show command is used here?

• A. show tcp brief
• B. show tcp brief all
• C. show tcp brief numeric
• D. show tcp brief ip

Question No. 3

SIMULATION

• A. check for details
• B. check for details

Question No. 4

What attribute is used to influence traffic from AS200 and AS300 so that it uses link1 to reach AS100.

• A. MED
• B. AS_path
• C. weight
• D. local preference

Question No. 5

Which two statements are examples of the difference between IPV4 and IPV6 EIGRP? (Choose two)

• A. Network command is not used m IPv6
• B. DUAL is used for route calculations
• C. IPv6 keyword is used in many EIGRP commands
• D. DUAL is not used for route calculations
• E. Network command is used in IPv6

Question No. 6

Engineer has to enable RIP on a link. Where he will issue the command?

• A. Ipv6
• B. Global
• C. Router sub command
• D. Interface sub command